地埋管换热器分区运行对土壤热堆积特性影响的研究

为了缓解埋管区域土壤的热量堆积问题,提出了埋管换热器按内中外、块状、间隔三种分区运行的策略,利用CFD软件建立了10×10的井群换热模型,对地源热泵系统在三种分区与不分区运行策略下运行十年进行数值模拟,分析不同分区运行策略对土壤温度分布和土壤热堆积特性的影响。模拟结果可知:不分区、内中外分区、块状分区、间隔分区四种运行策略下埋管区域的平均温度分别为25.23、23.31、23.06、23.28℃,最高温度分别为40.62、32.77、40.65、38.93℃;分区运行较不分区运行可以有效缓解热堆积作用,埋管区域整体温度较不分区运行时降低了2.00℃左右,内中外分区策略可以显著缓解埋管区域热堆积。     

Optimization of three-dimensional boiling enhancement structure at evaporation surface for high power light emitting diode

A theoretical model of phase change heat sink was established in terms of thermal resistance network. The influence of different parameters on the thermal resistance was analyzed and the crucial impact factors were determined. Subsequently, the forming methods including ploughing–extrusion and stamping method of boiling enhancement structure at evaporation surface were investigated, upon which three-dimensional microgroove structure was fabricated to improve the efficiency of evaporation. Moreover, the crucial parameters related to the fabrication of miniaturized phase change heat sink were optimized. The heat transfer performance of the heat sink was tested. Results show that the developed phase change heat sink has excellent heat transfer performance and is suitable for high power LED applications.     

太阳能及空气源热泵复合供热系统故障诊断研究与应用

为确保复杂太阳能热水系统的稳定运行,有必要采集实时运行数据从中获取故障特征信号,通过专家系统进行自动故障诊断。采用故障树分析方法,以太阳能热利用系统典型故障为例构建故障树,求解最小割集,并以此为基础建立诊断知识库;运用正向推理结合人工辅助决策机制进行故障诊断和定位,建立故障诊断专家系统。开发故障诊断软件,并在工程中进行测试,验证故障辨识的准确性。     

Heat Transfer Analysis of MHD Power Law Nano Fluid Flow through Annular Sector Duct

Flow and heat transfer analysis of an electrically conducting MHD power law nano fluid is carried out through annular sector duct,under the influence of constant pressure gradient.Two types of nano particles(i.e.Cu and TiO2)are used in power law nano fluid.Strongly implicit procedure,(SIP)is used to simulate the discretized coupled algebraic equations.It has been observed that volume fraction of nano particles,ϕand magnetic field parameter,Ha are favourable for the heat transfer rate,however,both resist the fluid flow.Impact of applied uniform transverse magnetic field exceeds in the case of shear thickening fluids(i.e.n>1)by increasing the value of Ha as compared to that in shear thinning fluids(i.e.n<1).Therefore,enhancement in heat transfer rate is comparably more in shear thickening fluid.Furthermore,comparable limiting case study with published result is also carried out in this research paper.     

某船用柴油机排气管路流-固耦合计算与保温效果研究

对某船用柴油机排气管路的流动与传热过程开展流-固耦合仿真分析。结果表明:受排气管路结构影响，管内流动方向和流速发生变化，局部区域产生明显的回流现象；排气管路外表面温度分布差异较大，平均温度高达534 ℃。为达到柴油机安全设计要求，在排气管路外壁敷设保温材料。分析结果表明:气凝胶纳米材料的保温效果优于硅酸铝纤维材料，在相同的运行条件和使用要求下，气凝胶纳米材料的敷设厚度更薄。     

Potential of performance improvement of concentrated solar power plants by optimizing the parabolic trough receiver

This paper proposes a comprehensive thermodynamic and economic model to predict and compare the performance of concentrated solar power plants with traditional and novel receivers with different configurations involving operating temperatures and locations. The simulation results reveal that power plants with novel receivers exhibit a superior thermodynamic and economic performance compared with traditional receivers. The annual electricity productions of power plants with novel receivers in Phoenix, Sevilla, and Tuotuohe are 8.5%, 10.5%, and 14.4% higher than those with traditional receivers at the outlet temperature of 550°C. The levelized cost of electricity of power plants with double-selective-coated receivers can be decreased by 6.9%, 8.5%, and 11.6%. In Phoenix, the optimal operating temperature of the power plants is improved from 500°C to 560°C by employing a novel receiver. Furthermore, the sensitivity analysis of the receiver heat loss, solar absorption, and freeze protection temperature is also conducted to analyze the general rule of influence of the receiver performance on power plants performance. Solar absorption has a positive contribution to annual electricity productions, whereas heat loss and freeze protection temperature have a negative effect on electricity outputs. The results indicate that the novel receiver coupled with low melting temperature molten salt is the best configuration for improving the overall performance of the power plants.     

Features of Cattaneo‐Christov heat flux model for Stagnation point flow of a Jeffrey fluid impinging over a stretching sheet: A numerical study

The present work focuses on a two‐dimensional steady incompressible stagnation point flow of a Jeffery fluid over a stretching sheet. The Cattaneo‐Christov heat flux model is incorporated into this study. Simulation is conducted via the Runge‐Kutta fourth‐order cum shooting method for the transformed system of nonlinear equations. The influence of the governing parameters on the dimensionless velocity, temperature, skin friction, streamlines, and isotherms is incorporated. A significant outcome of the current investigation is that an increase in the relaxation time parameter uplifts temperature; however, a gradual decrease is observed in the velocity field. Another important outcome of the present analysis is that the momentum boundary layer augments due to an increase in the Deborah number; however, a decrease is observed in the temperature. Furthermore, it is also observed that the skin friction coefficient escalates with an increase in the relaxation time parameter for the assisting flow, but a reverse trend is observed for the opposing flow.     

Stability and thermophysical properties of fly ash nanofluid for heat transfer applications

Improving the performance of heat transfer fluids is altogether significant. The best approach for improving the thermal conductivity is the addition of nanoparticles to the base fluid. In the present study, specific heat, dynamic viscosity, and thermal conductivity of water-based Indian coal fly ash stable nanofluid for 0.1% to 0.5% volume concentration in the temperature range of 30 to 60°C has been investigated. To evaluate an average particle diameter of 11.5 nm, the fly ash nanoparticles were characterized with scanning electron microscopy and dynamic light scattering. Using zeta potential, the stability of nanofluid in the presence of surfactant Triton X-100 was tested. Thermal conductivity and viscosity of fly ash nanofluid increased, while specific heat decreased as volume concentration increased. The effect of temperature on the fly ash nanofluid was directly proportional to its thermal conductivity and specific heat and inversely proportional to viscosity.     

带有蓄热型直接冷凝式加热板的空气源热泵系统性能研究

针对现有的空气源热泵冬季供热系统，提出了一种使用新型蓄热型直接冷凝式加热板（RHP）的空气源热泵供热系统，并测试了RHP的热性能和系统的运行特性，同时分析了系统的效率和经济性。实验结果表明，在39℃的冷凝温度下，RHP的热容量高达1044 W，RHP的蓄热量大于1000 kJ。在室外空气温度为8℃时，系统COP高达3.7。此外，对于20 m²的居住房间而言，该系统的供暖初始投资成本和总运行成本分别为3174.7 CNY和510.7 CNY，在居住建筑冬季供暖领域具有较大的竞争力。     

基于钠基吸附剂的烟气脱碳系统余热利用研究

针对基于钠基固体吸附剂的燃烧后脱碳技术应用于燃煤电厂后综合能耗偏高的问题，本文提出与供热机组结合的碳捕集/供热双机组系统，利用低温热网回水回收系统低品位余热。依据双机组的抽汽混合与否构建了两种系统流程，分析了两种不同方案下的系统性能。研究结果表明，在有效回收脱碳系统碳酸化反应余热后，独立抽汽方案中碳捕集综合能耗从4.05GJ/t CO₂降低至1.26GJ/t CO₂，而混合抽汽方案中碳捕集综合能耗降低至1.13GJ/t CO₂，同时双机组系统的热网供热量较单供热机组分别增加了67.5%和72.8%，经济效益显著。分析了混合抽汽方案的系统中碳捕集综合能耗随相关运行参数变化的规律，发现碳酸化反应温度和热网回水温度因为能够直接影响系统余热利用程度因而更易对碳捕集综合能耗产生影响。